HAISDA Mosaic Pins for Knife Handle - Custom Knife Scales & Grips - 9.5cm (5mm) EDC Pocket Hunting Folding Knife Pivot Pins - Perfect for DIY Knife Making, Blade Repair & Tactical Gear Customization

Mosaic Pins for Knife Handle Custom Knives Blank Scales Grips Blades, Brass Copper Stainless Steel for EDC Folding Pocket Knives PinThis unique mosaic pin was handcrafted by an expert. Add that extra bit of flair to your knife handle! This pin can be used for knife making, metal work, jewelry etc. It can be used as a solid pin or sliced into thin pieces for inlays. The pattern exists along the entire pin length.We use only the highest quality brass, copper and stainless steel.This pin requires a hole of 1cm to be drilled into the handle of your knife. You simply need to use drill bits intended for drilling metal, which are capable of drilling through the steel type of your bladeDo not expose to excessive heat when cutting the pins (it will become damaged over 95 degrees celsius). Do not polish them too much.Use only sandpaper for polishing. Use 1200 grit sandpaper for final polishing.And last, use lacquer or oil.Our mosaic pins have been vacuumpumped to remove air bubbles. The resin is pulled in with a highend vacuum, which pulls the glue down, and removes any small bubbles. The pins are cured afterward and lastly polished and burrs removed.The center of the mosaic pin is filled with clear epoxy resin. The filling will appear dark when initially received, however light will be able to shine through when you are done cutting this down to small pieces for your knife handle. The transparency will become evident with the smaller length pieces. As a note: It is possible to drill a knife blank's pin holes larger (or create your own pin hole locations). You simply need to use drill bits intended for drilling metal, which are capable of drilling through hardened high carbon steel. This method is recommended because you be able will get the exact fit you are looking for when using our mosaic pins.

Materialbrass stainless steel and copper,mosaic pins are hand-crafted for knife maker

Our mosaic pins have been vacuum-pumped to remove air bubbles. The resin is pulled in with a high-end vacuum, which pulls the glue down, and removes any small bubbles. The pins are cured afterward and lastly polished and burrs removed.

Diameter 5mm,Length9.5cm,You get 1 piece of mosaic pin stock with each order for knife handles.You can cut any length as your knife handle thickness,great gift for your custom knives craftsman

It is better for approximately 1/8" extends beyond the scales before you start sanding.

Once your knife handle has been built, it is recommended to keep the exposed surfaces of the mosaic pin protected with clear varnish/lacquer.